U.S. Army Soldier Systems Command, Acquisition Directorate, Attn: AMSSC-AD, Natick, MA 01760-5011

83 -- VESTIBULE FLY FOR TEMPER TENT SOL DAAD16-99-T-1000 DUE 041599 POC Tammy A. Taylor, Contract Specialist E-MAIL: contact Tammy Taylor at above e-mail address for information, ttaylor@natick-amed02.army.mil. TEMPER TENT VESTIBULE FLY REQUEST FOR QUOTATION DAAD16-99-T-1000. This synopsis/solicitation is amended for the purpose of CORRECTING errors that are located on the drawing packages associated with this acquisition. The original synopsis/solicitation was posted in CBDNet on 23 March 1999 and in the printed issue on 25 March 1999. The following changes are in effect: 1.) On drawing 5-4-7962, the 18'0" reference dimension represents the APPROXIMATE cut lengths of the pattern parts. 2.) Drawing 5-4-7962 has two sections labeled B-B. The section to the right, which is closest to the drawing identification block, should be labeled Section C-C. 3.) On drawing 5-4-7962 and Parts List PL5-4-7962, the following items are DELETED and are not required to procure the Vestibule Fly items under this synopsis/solicitation: Find Number 5(-1 & -2) Cord, Fibrous, Nylon; Find Number 8 Pin, Tent Metal Type III; Find Number 9, Grommet, Metallic, Rolled Rim, Size No. 0. 4.) On Parts List PL5-4-7962, under the nomenclature for Find Number 3(-1 & -2) DELETE "Type XV" and SUBSTITUTE "Type VIIIb". Also DELETE "Finnish per MIL-W-27265, Class R". 5.) On Parts List PL5-4-7962 under the nomenclature for Find Number 12, DELETE "Size FF" and SUBSTITUTE "Size F for needle and bobbin". 6.) On drawing 5-4-7962, the three reinforcements identified as Find Number 11 are depicted as being sewn to the body of the fly after the Middle (5-4-7964) and End (5-4-7963) pattern pieces have been joined together. These reinforcements MAY, as an alternate method of construction, be pre-cut and pre-attached to the pattern pieces and then rejoined in the feld seam operation depicted in Section B-B. 7.) On drawing 5-4-7962, in Note 6, DELETE "tie overhand knot as shown" and replace with "tie an overhand knot at one end of item 6 and a loop knot at the other end to form a 6" loop". Except as stated herein, all data referenced on the drawings under this combined synopsis/solicitation remain unchanged. The due date for receipt of quotations remains 1530 hours (3:30 PM EST) on 15 April 1999. Posted 03/31/99 (W-SN315011). (0090)

Loren Data Corp. http://www.ld.com (SYN# 0663 19990402\83-0001.SOL)