SOLICITATION NOTICE
70 -- NETWORK RENOVATION - DATA EQUIPMENT AND CABLE
- Notice Date
- 5/16/2008
- Notice Type
- Modification/Amendment
- NAICS
- 518210
— Data Processing, Hosting, and Related Services
- Contracting Office
- Department of Transportation, Maritime Administration (MARAD), U.S. Merchant Marine Academy (Procurement), MMA-5206, Division of Procurement, Kings Point, New York, 11024-1699
- ZIP Code
- 11024-1699
- Solicitation Number
- DTMA5R08101
- Response Due
- 5/21/2008 12:45:00 PM
- Point of Contact
- Maxmillian S Diah,, Phone: 516-773-5584, Gregg Wanlass,, Phone: 516-773-5435
- E-Mail Address
-
diahm@usmma.edu, wanlassg@usmma.edu
- Small Business Set-Aside
- Total Small Business
- Description
- This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; proposals are being requested and a written solicitation will not be issued. The solicitation number is DTMA5R08101 and is being issued as a request for proposal (RFP). The solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular FAC 05-15. This requirement is a total set-aside for small business. Offers received from concerns that are not small business concerns shall be considered non-responsive and will be rejected (in accordance with FAR 52.219-6 Notice of Total Small Business Set-Aside which applies to this solicitation). The associated North American Industrial Classification System (NAICS) code for this procurement is 518210 with a small business size standard of $23.0 million. The contract will include the following CLINs.: NOTE: FITTINGS - STEEL COMPRESSION ONLY 0001 CONDUIT 11/4" QTY: 150 U/I: FT 0002 CONDUIT 1" QTY: 1000 U/I: FT 0003 CONDUIT ¾" QTY: 1000 U/I: FT 0004 CAT6 CABLE QTY: 38,000 U/I: LFT. 0005 DROPS JACKS AND COVERS QTY: 152 U/I: EA (LEVITON) 0006 304 TERMINATIONS QTY: 304 U/I: EA 0007 OPEN NETWORK RACK QTY: 1 U/I: EA CPI-#46353-703 0008 HORIZONTAL WIRE MANAGERS QTY: 2 U/I: EA CPI - 0009 VERTICLE WIRE MANAGERS QTY: 2 U/I: EA CPI-#40098-703 0010 CABLE RUNWAY 18" (Field Measure) QTY: UNK U/I: FT CPI 0011 BRIDLE RINGS AND SADDELS QTY: 600* U/I: EA EVERY 4' (*Approximate) 0012 48 CAT6 PATCH PANELS QTY: 4 U/I: EA LEVITON 0013 LABOR SITE INSPECTION The performance site will be available for inspection on Thursday, 8 May 2008 at 9:00 A.M. Eastern Standard Time (EST). It is highly recommended that interested small business concerns attend this site inspection. STATEMENT OF WORK FOR THE DATA NETWORK REWIRING OF FULTON AND GIBBS HALL SECTION A - Scope A.1 Contractor shall provide all labor, materials, tools, equipment, supervision necessary for all and terminations and to run all EMT (conduit), pull boxes, fire stop and CAT 6 cable (plenum rated), CAT 6 jacks and plates throughout Fulton Hall (structure is reinforced concrete columns and slabs with non-bearing block walls) and Gibbs Hall (structure is steel columns and reinforced concrete slabs with non-bearing block walls) buildings, located at the United States Merchant Marine Academy, Kings Point, New York. The total number of drops are 152 [304 terminations (152 x 2)]. SECTION B - General Requirements Ground Level B.1 Contractor shall install 1 ¼" EMT from the main floor closet to the lower level and drill out as necessary and install a pull box, from the pull box run 1 ¼" EMT for approximately 100' and install a 2nd pull box. B.2 Contractor shall provide and install 1" EMT from the 2nd pull box approximately 40' to room G18. Install box at entry to G18 and transition to ¾" for two locations in G18 within 30' and run ¾" 150' to welding shop, also install a 2nd pull box approximately 160' to feed G26 and office G12. Additional drops shall be installed in G06 lecture hall for wireless, G05 and G03. *NOTE: Contractor must use Fire Stop on all Pipe Penetrations. 3rd Floor North & 4th Floor B.3 Contractor shall install pulling hardware in the 4th floor ceiling to room 405, sleeve wall of room 309 and use existing riser to 4th floor janitors' closet for cable to room 405 and telescope. B.4 Contractor shall install EMT pipe in janitors closet to feed telescope and in room 405 for 3 locations 5 cables in all. B.5 Contractor shall pull cables for the following room to pull box in ceiling outside room 309 and use existing conduits from pull box to ceiling area above rooms. This will connect the following room locations: Room 323 - 2 cables Conference room 322 - 4 cables 1 location at front under white board Room 321 - 2 cables Room 320 - 3 cables Rooms 315, 316, 317, 318 & 319 - cable each room total 5 cables Rooms 310, 311, 312 & 314 - total of 7 cables Rooms 406 - 2 drops; 407, 408 - 2 drops, 409, 410 - 2 drops, 411, 412, 413,414, 415 & 416 - 1 cable each room total 11 cables. 3rd Floor South B.6 Contractor shall install pulling hardware in hallway ceiling area, sleeve wall in rooms 342 for new cable installation to riser and install risers down to 1st floor. The following rooms are open ceilings and require pipe to all locations: 307 Gibbs - 3 locations 5 cables/305 Gibbs - 3 locations / 304 Gibbs - 3 locations 5 cables / 301 Gibbs - wireless access point only 302 1 drop. B.7 Contractor shall pull to the following rooms using existing pipe from room 342 to ceiling area above rooms: 304 3 drops, 305, 306 & 307 - cable each total of 6 cables 325, 326, 327 & 328 - 1 cable each total of 4 cables 329, 330, 331, 332 & 328 - 1 cable each total of 5 cables Room 303 - 2 cables Room 333 - 3 cables Room 334 - 2 cables Room 335 - 2 cables Office areas 336, 337, 338, 339, 340 3 drops FAX machines & 341 total of 11 cables 2nd Floor B.8 Contractor shall install pulling hardware in the hallway ceiling area, sleeve wall in the 2nd deck floor closet and install a riser to the 1st floor, install bridle rings in rooms with drop ceilings for cable support Room 209: wire projector and wireless location, install pipe on front wall for termination of 3 cables Rooms 207,208 & 210 currently have 4 existing cables from the lectern back to the main floor wiring closet: terminate 3 cables in lectern, pull back one cable for wireless location, install a new cable for the projector location. The remaining rooms have open ceilings and require pipe to all locations: 213 Fulton - 3 locations 5 cables 204 Fulton - 3 locations 5 cables 203 Fulton - 3 locations 5 cables 212 Fulton - 3 locations 5 cables 214 Fulton - 3 locations 5 cables 208 Gibbs - 1 location 1 cable 212 Gibbs - 1 location 1 cable 215 Gibbs - 3 locations 5 cables 204 Gibbs - 3 locations 5 cables 205 Gibbs - 3 locations 5 cables 207 Gibbs - wireless access point only 1st Floor B.9 Contractor shall set up room 118 as wiring closet for building: install rack with full vertical & horizontal wire management, install overhead cable runway from rear side and front wall to route cables to rack to secure top of rack, install patch panels to cover building and necessary switches, sleeve front wall for new cable entry, extend existing new cables over to rack with high band blocks, install pulling hardware in hallway ceiling area, install bridle rings in drop ceilings of rooms 115, 101 & 102 for cable support. The following areas shall have 5 cables per room in 3 locations: Room 115 & 101: Projector and wireless locations, 3 cables to podium, requires 1" pipe from drop ceiling to floor. Drill through floor to floor below and drill under podium to bring up 3 cables and terminate. Room 102: Projector and wireless locations, install pipe on front wall for termination of 3 cables. The following rooms are open ceilings and will require pipe to all locations: Room 105A - 2 locations 2 cables Room 105B - 2 locations 2 cables Room 105 - 1 location 1 cable Room 114 - 3 locations 5 cables Room 104 - 3 locations 5 cables Rooms 111, 110 & 107 will require wireless locations only to be mounted on the wall next to the hallway. OTHER B.10 This project consist of drop ceiling work with approximately 55% of the cable paths above drop ceilings. In addition, some concrete drilling will be necessary. B.11 Contractor shall develop and fulfill a parts and materials list. All items shall meet or exceed all applicable Electrical and/or Building codes for Nassau County, NY. SECTION C - Testing C.1 Contractor upon completion of all terminations shall test each cable run, termination and operation of each data circuit. SECTION D - General Notes D.1 Personnel in the employ of the contractor shall in the operation of motor vehicles possess a valid state driver's license. D.2 Contractor shall furnish in writing, a complete guarantee to the Contracting Officer's Technical Representative (COTR) against all defective materials and improper workmanship for all parts, components and operation for a period of one year from the date of final acceptance. D.3 All work must be scheduled, with the COTR, at least 48 hours before work is to be performed. D.4 Interruption of any services to any part of the Academy will be as short as possible. All work in connection with services, equipment, etc. will be prepared in advance and only with prior approval of the COTR. D.5 Contractor shall ensure that all repairs to the interior of each building shall match existing conditions. D.6 Blueprints are available upon request. D.7 All work shall meet or exceed the Electrical (and other applicable Building) codes for Nassau County, NY. PERFORMANCE PERIOD 17 June 2008 - 18 August 2008 PERFORMANCE LOCATION U.S. Merchant Marine Academy (USMMA) Fulton Hall and Gibbs Hall 300 Steamboat Road Kings Point, NY 11024-1699 TERMS OF DELIVERY Delivery shall include Free on Board (F.O.B.) Destination Terms Applicable DOL Wage Determination applies to this solicitation and shall be incorporated into any resulting contract. The clause at 52.212-1, Instructions to Offerors-Commercial Items, (Sep 2006) is incorporated by reference and applies to this acquisition. The provision at 52.212-2 Evaluation-Commercial Items (Jan 1999) applies to this acquisition. (a) The Government will award a contract resulting from this solicitation to the responsible offeror whose offer conforming to the solicitation will be most advantageous to the Government, price and other factor(s) considered. The following factors shall be used to evaluate offers: (i) price and (ii) past performance. Each offeror shall include a completed copy of the provision at 52.212-3 (Nov 2006) or certification that these have been completed online via Online Representations and Certifications application (ORCA) at https://orca.bpn.gov. FAR 52.212-4 Contract Terms and Conditions--Commercial Items (Feb 2007) is incorporated by reference and applies to this acquisition. FAR 52.212-5 Contract Terms and Conditions Required to Implement Statutes or Executive Orders --Commercial Items (Jun 2007), is incorporated by reference, however, only the following clauses apply to this acquisition: 52.219-6, 52.222-3, 52.222-19, 52.222-21, 52.222-26, 52.222-36, 52.225-1, 52.225-3 and 52.232-33. Numbered notes: Not applicable. SITE INSPECTION: THURSDAY, 8 MAY 2008 @ 9:00 A.M. EST. All contractor questions shall be submitted in writing and are due via mail or email (diahm@usmma.edu) no later than 3:00 P.M. EST, Thursday, 15 May 2008. PROPOSALS ARE DUE NO LATER THAN 12:45 P.M. EST ON WEDNESDAY, 21 MAY 2008. DELIVER OR MAIL PROPOSALS TO: U.S. Merchant Marine Academy Attention: Maxmillian Diah Procurement Department Room 212 300 Steamboat Road Kings Point, NY 11024-1699. NOTE: All proposals must be delivered or mailed. Email and fax proposals ARE NOT acceptable. Proposals submitted by email or fax shall be considered non-responsive and will be rejected. For information regarding this solicitation, please contact: Maxmillian Diah, Contract Specialist Phone (516) 773-5584, Fax (516) 773-5251, Email: diahm@usmma.edu or Gregg Wanlass, Contracting Officer Phone (516) 773-5435, Fax (516) 773-5251 Email: wanlassg@usmma.edu
- Web Link
-
FedBizOpps Complete View
(https://www.fbo.gov/?s=opportunity&mode=form&id=da106788f87e78f9812a8b4cd4fddbcf&tab=core&_cview=1)
- Place of Performance
- Address: U.S. Merchant Marine Academy, 300 Steamboat Road, Kings Point, New York, 11024-1699, United States
- Zip Code: 11024-1699
- Zip Code: 11024-1699
- Record
- SN01575674-W 20080518/080516221658-da106788f87e78f9812a8b4cd4fddbcf (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |