SOLICITATION NOTICE
66 -- Electroantennography
- Notice Date
- 5/13/2008
- Notice Type
- Combined Synopsis/Solicitation
- NAICS
- 334516
— Analytical Laboratory Instrument Manufacturing
- Contracting Office
- Department of Agriculture, Agricultural Research Service, Mid South Area Office, 141 Experiment Station Road, Stoneville, Mississippi, 38776
- ZIP Code
- 38776
- Solicitation Number
- 2008-4431-012
- Point of Contact
- Terry V. Jones, Phone: 662-686-3038, Terry A Krutz, Phone: 662-686-5361
- E-Mail Address
-
terry.jones@ars.usda.gov, terry.krutz@ars.usda.gov
- Small Business Set-Aside
- N/A
- Description
- Electroantennography Detector Solicitation No. 2008-4431-012 The USDA, ARS, Mid South Area, intends to Sole Source purchase a Electroantennography (EAG) from Syntech of Kirchzarten, Germany. This EAG must be compatible with and will be connected to an existing Varian Model: CP-3800 GAS Chromatography. This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; bids are being requested and a written solicitation will not be issued. Solicitation number 2008-4431-012 is being issued as an Invitation for Bid. This solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular 97-12. Offerors are to provide a bid for the following: SPECIFICATIONS: 1. 4-CHANNEL USB ACQUISITION CONTROLLER, type IDAC-4 4-channel amplifier / data-acquisition system for the Universal Serial Bus (USB). For use with any PC (and portables) with USB port. Real-time on screen display of all signals before and during recording Fully software programmable: Gain, Offset, Filters, Command inputs, etc. 50/60 Hz filter and zero offset control; special EAG filter Sampling rate (1/s - 100k/s) adjustable for each channel individually Powered inputs for active sensors and headstages (Probes) Voice comments can be recorded with data All inputs and outputs galvanically isolated DIRECT OUTPUTS for up to 8 external solenoids (valves) and actuators DIRECT OUTPUTS for 2 proportional actuators (lights, flow controllers, motors, etc.). Programmable time sequence of actuator (solenoids and motors) outputs Graphical time sequence actuator control program Actuator sequence runs simultaneously with signal acquisition 2. EFFLUENT CONDITIONER ASSEMBLY, Type EC-03 Heated transfer line for GC-EAD Digital temperature controller max. 320 °C Effluent /Air mixing assembly with Interchangeable flow tube Adapted to fit available Gas Chromatograph Heater separated from mains via isolation transformer 3. STIMULUS CONTROLLER UNIT, Type CS-55 with built-in air pumps Replaces previous model CS-05 Independent from laboratory air supply Internal vibration compensated air pumps Built-in activated carbon inlet filter Filter can be easily replaced Delivers continuous and pulsed air flow Graphic LCD display Flow range 10 - 50 ml/s, non-calibrated Pulse duration 0.1 - 60 s in 0.1s increments Repeat function: interval range 1- 60 s. Signal outputs compatible with Syntech recording systems Suitable for EAG and GC/EAD and SSR procedures Including foot operated start switch 4. MICROMANIPULATOR, Type MP-22 Very compact integral universal recording module Dual joystick type x-y-z micromanipulators Suitable for glass pipette and tungsten electrode recording Including High impedance input probe and different electrode holder Indifferent electrode holder Connects directly to Syntech IDAC computer interface No amplifier needed if used in combination with IDAC computer interface Adjustable preparation holder Adjustable air flow tube 5. UNIVERSAL SINGLE ENDED PROBE, Type PRS-1 High impedance electrometer type input OpAmp Guarded input shield extends over pipette holder Electrode directly connected to input of electrometer OpAmp Stainless steel pipette electrode holders included Easy replaceable silver wire (no soldering) Complete with indifferent electrode holder on stainless steel shaft 6. EAG and GC/EAD SIGNAL RECORDING and ANALYSIS PROGRAM For use with Syntech IDAC data acquisition systems Auto zero on trigger signal of base line and time base Real-time recording and display of ElectroAntennogram signals (EAG) Calculation and display of EAG maxima and Normalized values Calculation and display of means and standard deviations Dual trace real-time recording of combined Gas chromatography-Electro Antennographic Detection (GC/EAD); max 5 hours continuous recording Peak area calculation and retention time marking on GC and EAD trace Amplitude and time-base zooming Comments stored with data Graphic output in Windows metafile format Printing of all graphic and numeric data ASCII data output 7. Gerstel Effluent Splitter This equipment shall be delivered F.O.B. Destination to the USDA, ARS, located in Stoneville, MS. "This procurement requires the use of biobased products to the extent that such products are reasonably available, meet agency or relevant industry performance standards, and are reasonably priced. Where available, these products should first be acquired from among qualified products that fall under the umbrella of items designated through the Federal Biobased Products Preferred Procurement Program (FB4P)" Equipment Line Items: UNIT NO. SUPPLIES/SERVICES QTY UNIT PRICE AMOUNT 01 Electroantennography Detector 1 EA $__________ TOTAL $_________ All systems and components shall be provided with a one (1) year warranty from the time of owner's acceptance. The warranty shall cover all parts, labor and material. Delivery of the unit by the instrument vendor must be within 15 days of award of contract. ALL RESPONSIBLE SOURCES MAY SUBMIT A BID FOR CONSIDERATION. Bid prices shall include all necessary labor, parts, materials, and transportation necessary to delivered FOB Destination a Electroantennography Detector to USDA, ARS, 59 Lee Road, Stoneville, MS 38776. This contract incorporates one or more clauses by reference, with the same force and effect as if they were given in full text. Upon request, the Contracting Officer will make their full text available. Also, the full text of a clause may be accessed electronically at this/these address(es): www.arnet.gov/far/. FAR 52.212-1 Instructions to Offerors - Commercial, Far 52.212-2 Evaluation-Commercial Items, FAR 52.212-3 Offeror Representations and Certifications-Commercial Items, FAR 52.212.4 Contract Terms and Conditions-Commercial Items, FAR 52.212-5 Contract Terms and Conditions Required to Implement Statues or Executive Orders - Commercial Items apply to this acquisition. All systems and components shall be provided with a one (1) year warranty from the time of owner's acceptance. The warranty shall cover all parts, labor and material. Offers are to include a 30 calendar day acceptance period. All bids are due by 2:00 p.m. (CST), May 29, 2008 at the USDA, ARS, MSA, Procurement Assistance Office, 141 Experiment Station Road, P.O. Box 225, Stoneville, MS 38776-0225 faxed to 662-686-5373 or emailed to terry.jones@ars.usda.gov. Delivery of the unit by the equipment vendor must be within 15 days of award of contract. The Point of contact for this project is Terry Jones (662) 686-3038 or terry.jones@ars.usda.gov.
- Web Link
-
FedBizOpps Complete View
(https://www.fbo.gov/?s=opportunity&mode=form&id=828a314e18614681628fdebf76fffc42&tab=core&_cview=1)
- Place of Performance
- Address: USDA-ARS, 59 Lee Road, Stoneville, Mississippi, 38776, United States
- Zip Code: 38776
- Zip Code: 38776
- Record
- SN01571991-W 20080515/080513220645-828a314e18614681628fdebf76fffc42 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |