Loren Data's SAM Daily™

FBO DAILY ISSUE OF FEBRUARY 26, 2006 FBO #1553
SOLICITATION NOTICE

J -- STATOR WINDING REPAIR (GENERATING UNIT 15) AT cHIEF JOSEPH POWERHOUSE BRIDGEPORT, WA

Notice Date

2/24/2006
 

Notice Type

Solicitation Notice
 

NAICS

811310 — Commercial and Industrial Machinery and Equipment (except Automotive and Electronic) Repair and Maintenance
 

Contracting Office

US Army Engineer District, Seattle, ATTN: CENWS-CT, PO Box 3755, Seattle, WA 98124-3755
 

ZIP Code

98124-3755
 

Solicitation Number

W68MD9-6053-7864
 

Response Due

2/27/2006
 

Archive Date

4/28/2006
 

Small Business Set-Aside

N/A
 

Description

**THIS SYNOPSIS PROVIDES FOR A SOLE SOURECE PROCUREMENT TO VOITH SIEMENS HYDRO POWER GENERATION, INC.** The scope for this procurement consists of the Contractor furnishing supervision, engineering, labor, materials, and equipment to repair the stator winding of Generating Unit 15 at Chief Joseph Powerhouse in accordance with the detailed requirements of the statement of work. Initial Condition: The initial condition at the start of work is that the generator has been disassembled and the rotor removed to allow access to the stator. There is a stator winding fault in the connection between coil groups B1 and B2. Also, a few connections in the vi cinity of the failure appear to have suffered minor surface damage from the fault. The failed and damaged connections have been gently cleaned; otherwise, no repairs have been made to the affected area. A 5000-volt insulation resistance test and a17.8-kV ac withstand test have been successfully performed on all three stator winding phases. Description of Work: The basic work to be performed by the Contractor under this task order consists of the following: 1. Perform mobilization and demobilization. 2. Repair stator winding damage. (a) Repair the failed coil group connection. (b) Repair the insulation of the series and group connections damaged by the failure. (c) Remove the ground insulation from an undamaged group connection to allow Government to perform visual inspection of copper conductor, strand insulation, and transposition. Replace insulation after inspection is complete. (d) Witness Government-performed tests and measurements to verify the success of the repair. Tests will be performed on all three phases and shall include micro-ohm winding resistance measurements, insulation resistance and polarization index measure ments at 5 kV dc, and one-minute ac high potential withstand test at 17.6 kV rms. (e) Make corrections, as necessary, to pass the above tests. The North American Industry Classification System (NAICS) Code is 811310, which is matched to SIC code 7699. Project is open small business only. Additional contracting opportunities, visit the Army Single Face to Industry at https://acquisition.army.mil/ .
 

Place of Performance

Address: US Army Engineer District, Seattle ATTN: CENWS-CT, PO Box 3755 Seattle WA

Zip Code: 98124-3755

Country: US
 

Record

SN00994416-W 20060226/060224212557 (fbodaily.com)
 

Source

FedBizOpps Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's FBO Daily Index Page |