SOLICITATION NOTICE
56 -- NATO Project Number 3AF-50321, Item 105
- Notice Date
- 3/9/2004
- Notice Type
- Solicitation Notice
- NAICS
- 236210
— Industrial Building Construction
- Contracting Office
- Department of Commerce, Bureau of Industry & Security, Defense Programs Division, Office of Strategic Industries and Economic Security 14th and Pennsylvania Avenue, NW, Room 3876, Washington, DC, 20230
- ZIP Code
- 20230
- Solicitation Number
- N33191-02-B-1065
- Response Due
- 3/26/2004
- Archive Date
- 4/10/2004
- Point of Contact
- Etta Munford, Industrial Specialist/NATO Procurement, Phone 202-482-8240, Fax 202-482-5650, - Etta Munford, Industrial Specialist/NATO Procurement, Phone 202-482-8240, Fax 202-482-5650,
- E-Mail Address
-
EMUNFORD@bis.doc.gov, EMUNFORD@bis.doc.gov
- Description
- PROJECT INFORMATION – CONTRACT: N33191-02-B-1065 NATO PROJECT Number 3AF- 50321, ITEM 105 ZAPPALA ROADS/UTILITIES PHASE 3-INCREMENT 2-COMMUNICATIONS CABLING 1. PROJECT GENERAL SCOPE OF WORK This is the NATO funded construction project. The project is located in Aviano Air Base, Italy. The scope of work includes installation of a communication network and two routing structures located within the Flight Line and Zappala Area. Construction is planned for a network of duct bank encompassing the Flight Line and connecting to an existing duct bank system in the Zappala area. Demolition work is considered minimal and limited to removal of trees, shrubs and fencing located along the duct bank alignment. The project is programmed to service the Integrated Communications Complex and provide for the increasing telecommunication and data transfer demands of Aviano Air Base. 2. SPECIAL CONDITIONS Site demolition: Demolition work includes demolishing and removal of approximately 10,000 sq. meter of 250mm thick asphalt pavement section and 30m of 150mm high concrete curb and gutter, 100sq meter of 400mm thick concrete taxiway section. Site Grading: Rough and fine grading of entire alignment and miscellaneous locations, totaling 65,000sq m site. Landscaping: Seeding and sodding of 55,000sq m of turf for areas disturbed by construction. Communications buildings: Walls: reinforced concrete with a combination of 3-coat system substrate. Exterior personnel doors: flush aluminum doors and frames with stainless steel hardware including overhead holders for equipment transfer. Foundation: reinforced cast-in-place concrete spread footing to support the columns and reinforced cast-in place concrete strip footings to support the exterior and interior concrete walls. Slab on grade: Ground floor construction will consist of a cast-in-place concrete slab on grade on capillary fill and polyethylene vapor barrier. The slab will be reinforced with welded wire fabric for shrinkage crack control. Structural system: consists of exterior and interior reinforced cast-in-place concrete bearing/shear walls supporting the attic slab. Supported floor: the supported floor is a reinforced cast-in-place concrete “attic” which serves to act as a diaphragm to distribute wind and seismic shear loads to the shear walls and to support suspended piping and miscellaneous equipment. HVAC: system utilizing split system air to air heat pumps. The split system shall be approximately 2 tons and shall utilize a direct expansion circuit for heating and cooling. Power system: rated for 220/380volts, 3 phase, 4 wire. All systems rated 50 hertz. No 60hertz systems in projects. Lighting system: consist of fluorescent lighting fixtures, industrial vapor proof style and emergency lighting. Fire alarm system: control panel will be the addressable style utilizing solid-state, modular design features. The fire alarm system will include manual pull stations, audio/visual alarm devices, smoke detectors, radio transmitter, exterior alarm device, and antenna. Grounding system will be required. Lightning Protection system shall be required for communications huts. Service Lines Communication service lines distribution system includes empty manhole and duct bank system, to extend from the duct bank backbone to service all existing and proposed facilities in Area F. Complete fiber optic and copper system cabling to fill both the backbone and service lines. Comprehensive site survey report: A comprehensive site survey of present conditions and integrating this survey into previously completed site surveys. Investigation also includes inspecting and documenting the existing communication system manholes in the Zappala area. 4. ANTICIPATED TIME TO COMPLETE THE WORK It is anticipated 24 months or 720 calendar days after the Award of the Contract for the construction of the project. 5. ADDITIONAL INFORMATION The Bid validity period will be 180 calendar days from bid closing date. Option(s) may be included in the bid schedule. The government may exercise the option(s) within 180 calendar days from award. This project does not contain classified information. This project is referenced as: Solicitation N33191-02-B-1065 NATO International Competitive Bidding (ICB) one-step procedure applies to this project.
- Web Link
-
Link to FedBizOpps document.
(http://www.eps.gov/spg/DOC/BIS/DPD/N33191-02-B-1065/listing.html)
- Place of Performance
- Address: Aviano Air Base, Italy
- Country: Italy
- Country: Italy
- Record
- SN00540655-F 20040311/040309225714 (fbodaily.com)
- Source
-
FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |